![]() The resulting edge will be “sword sharp” not razor sharp. Our sword sharpening expert has personally sharpened several thousand swords at this point, so will provide you with a professional service. We can sharpen only the last half or third of an edge, for example. If you have a different preference, feel free to make that request in the special instructions at check out. By default we will sharpen as much of the blade as possible including any false edges if appropriate. The blades are rested between passes to prevent them from becoming hot and damaging their temper. The process involves many passes with sanding belts of various grits. The sharpening service is done with a belt sander. We adjust the angle of the edge to suit the specific blade and attempt to get as close to a bevel-less edge as possible without marring the surface of the blade. Some blades will take and hold sharper edges than others and the thickness of the blade will determine how wide the bevel will need to be. The resulting edge is somewhat dependent on the particular blade. The result is typically “very sharp” with a small secondary bevel and a bit of an “apple seed” profile. Our sharpening service will provide a good serviceable edge on the blade. It is linked on this page with a thumbnail. Please Note: A Cor-Ex sheath for the axe blade is available and is sold separately. ![]() In such a position it will no longer function as intended. Care must be taken not to turn it too far as it is possible to drive the screw so far into the haft that the screw leaves the axehead socket entirely. There is a recessed, internal screw at the back of the socket which can be tightened with your own hex key wrench to re-seat the axe onto the haft should it begin to loosen. The axe lends itself best to two-handed use, but with the use of your own saw you could cut it down to your own preferred size. The beard-like bottom of the axe can be used for the variety of hooking techniques that skilled Viking axemen employed, and the upswept tip doubles as a piercing tip. The axehead is a good compromise in size and is large enough to deliver the mass and striking power needed for warfare, but is not so large as to be unwieldy and sluggish in the recovery. Thompson and custom bladesmiths Dave Baker and Rich McDonald. Designed to be a solid fighting axe, it was designed as a collaboration between Cold Steel President Lynn C. We'll also need a copy of your passport by email, scan, fax or mail.This Viking Axe has a strong head crafted from 1065 high carbon steel and it is securely mounted onto a robust haft of American Hickory. Please provide your birth date when ordering. We do not sell this product to customers under the age of 18. Handle material: straight-grain hickory Particularly suited to blades requiring impact resistance, it's often seen in large fixed blades and swords. The carbon content and lean alloy of this shallow hardening steel make this a very sturdy material that avoids a lot of the brittleness commonly associated with higher carbon materials. Like Cold Steel®'s Viking Bearded Axe, it comes with a premium 76 cm long American hickory handle which is long enough to accommodate two-handed use! This means you can stab, parry or hook shields or limbs with ease. It's drop forged and features a wide, curved cutting edge that terminates in horns or points on the ends. It's a cutting, chopping, stabbing dynamo that any Viking worth his salt would envy. Cold Steel®'s Viking Battle Axe is intended to be used as a stand-alone weapon, but it can be paired effectively with a sword, shield or long sax.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |